Stop and call a pro now if
- Siding is melting or scorched near a grill, fire pit or vent. Turn off the grill's burners and its gas supply, or put out the fire pit with water or sand. Move it away from the house only once it is cool. If the siding is on fire or you see smoke or smell burning from behind it, get everyone away and call 911, because fire can spread inside the wall.
- Warped boards come with soft or rotting wall sheathing, or water stains inside the house. Water is getting behind the siding, and that needs a contractor soon.
Likely causes
-
Nails driven too tight
InterNACHI says fastener heads should leave about 1/32 inch of clearance from the siding's nailing hem so panels can slide. Nails driven tight pin the panel and it buckles as it expands.
-
Crooked or off-center nails, or face nailing
InterNACHI notes distortion can come from fasteners not driven straight and level or not centered in the nailing slot. Nailing or stapling through the face of the panel causes ripples.
-
Too little room at trim and corners
Vinyl needs space to expand at J-channel, corner posts and openings. InterNACHI calls for at least 1/4 inch of clearance.
-
Reflected sunlight from windows
PEPA, the vinyl siding industry group, explains that energy-efficient windows on the house or a neighbor's can concentrate sunlight enough to distort or melt siding. It isn't common, and it shows up as a localized patch.
-
A heat source too close
A grill or fire pit close to the wall can soften vinyl. So can a gas appliance vent installed without a heat shield.
-
Dark paint on light vinyl
Painting vinyl siding a darker color than it was made in makes it absorb more heat, and it can warp. Some manufacturers offer heat-rated colors for this.
-
Moisture behind wood siding
On wood siding, water getting into the boards is a common cause of warping. HomeGuide recommends replacing cracked or warped wood boards.
What you can safely check
Look closely from the ground. The pattern of the damage usually tells you the cause.
-
Look at the pattern
Long waves running across a whole wall point to installation. A melted or wrinkled patch on one spot points to heat. Note which wall it is on and if it is near a window or grill.
-
Check if it changes with the weather
Buckling from tight nailing often gets worse on hot afternoons and eases when it cools. A melted patch stays the same.
-
Look for a reflected sun spot
On a sunny day, check if a bright spot from a nearby window lands where the damage is. Don't stare into the glare. PEPA says screens, sunshades or plantings that block the reflection can prevent it.
-
Check the trim
See if panel ends are jammed tight into corner posts or J-channel with no gap.
-
Check for moisture
On wood siding, press warped boards gently with a gloved hand or a screwdriver handle. Soft wood or stains inside the house on that wall mean water.
Avoid these
- Nailing a warped vinyl panel flatter. That pins it tighter and makes buckling worse.
- Using a heat gun to reshape vinyl. Distorted vinyl usually needs the panel replaced.
- Prying panels off without a siding removal tool. You can crack the panel above.
When to call a pro
- Buckling covers more than a few panels or a whole wall.
- Panels are melted or distorted and need replacing.
- Warped wood siding has soft spots or signs of water behind it.
- The siding is new, so the installer's workmanship warranty may apply.
Tell the contractor when the siding was installed, which walls are affected, and whether the damage is long waves or a melted patch. For newer siding, check the installer's workmanship warranty first. For a reflection problem, ask about blocking the reflected light as well as replacing panels.
Typical repair costs
National ranges for parts and labor from HomeGuide. Matching color on older, faded siding can add cost.
Frequently asked questions
Why is my vinyl siding buckling?
Usually because it can't expand. InterNACHI points to nails driven too tight, crooked or off-center, and too little clearance at trim. It tends to show on hot days.
Can warped vinyl siding be fixed?
Panels that were simply pinned can often be rehung. Panels distorted by heat usually need to be replaced.
Can windows really melt siding?
Yes, though rarely. PEPA explains that energy-efficient windows can concentrate reflected sunlight enough to distort vinyl siding. Blocking the reflection with screens, awnings or plantings prevents it.
Is buckling siding covered by warranty?
Installation problems are usually a workmanship issue for the installer, not a product defect. Check your installer's warranty and the siding warranty for heat-distortion exclusions.
Sources
- Vinyl Siding Inspection , InterNACHI
- Understanding Concentrated Solar Reflection , Polymeric Exterior Products Association (formerly Vinyl Siding Institute)
- How Much Does It Cost to Repair Siding? , HomeGuide