8 Things to Do If Your Heat Stops Working During a Winter Storm (2026)

1. Check the thermostat settings and batteries first

Before assuming the worst, verify the thermostat is set to the correct mode (heat or cool), the setpoint is reasonable, and the batteries are not dead. Blank or flickering displays indicate dead batteries — replace them with fresh AAs. Programmable thermostats can have scheduling errors that switch modes at unexpected times. This 2-minute check solves the problem in roughly 10% of HVAC 'emergencies' and saves you a $150+ service call.

2 minutes

Pro tip: Set the thermostat to 'emergency heat' or 'auxiliary heat' if your heat pump is not working in freezing weather. This activates the backup electric strips, which are expensive to run but will keep your pipes from freezing while you wait for service.

2. Check and replace the air filter

A clogged air filter restricts airflow to the point where the system overheats (furnace) or freezes up (AC), triggering safety shutoffs. This is the most common cause of HVAC failure and the cheapest fix. Pull the filter and hold it up to a light. If you cannot see light through it, it is too dirty. Replace it, reset the system at the thermostat and breaker, and wait 30 minutes. This resolves 20–30% of residential HVAC emergencies at the cost of a $5 filter.

5 minutes

Pro tip: Keep 2–3 spare filters at home at all times. Running to the store for a filter during a heat wave or cold snap is stressful and unnecessary. Stock up when you replace one.

3. Check the circuit breaker for the HVAC system

HVAC systems have dedicated breakers — sometimes two: one for the air handler/furnace and one for the outdoor unit. Check your electrical panel for tripped breakers (the handle will be in the middle position, not fully on or off). Reset by pushing the handle firmly to 'Off' and then to 'On'. If the breaker trips again within 30 minutes, do not reset it a third time — repeated trips indicate an electrical fault that requires professional diagnosis.

2 minutes

Pro tip: If both the indoor and outdoor breakers are on but the outdoor unit is not running, check whether the disconnect box near the outdoor unit has been switched off. Service technicians sometimes leave it off after maintenance.

4. Keep your household safe while waiting for service

If heating fails in freezing weather: close off rooms you are not using, seal drafts around doors and windows with towels, move everyone to one room and use safe supplemental heat (electric space heaters, NOT gas grills or ovens). Open faucets to a thin stream to prevent pipe freezing. If cooling fails during extreme heat: close blinds, drink water frequently, use fans for air circulation, and check on elderly family members or pets who are heat-sensitive.

Ongoing

Pro tip: In a heating emergency, running hot water creates thermal mass that stays warm longer than air. Fill bathtubs and large pots with hot water (while you still have hot water) to add warmth to the room.

5. Do NOT use your oven or gas stove for heating

Every winter, people die from carbon monoxide poisoning caused by running gas ovens for heat. Gas appliances designed for cooking are not designed for continuous operation as heaters — they produce carbon monoxide, and kitchen ventilation is not rated for continuous burn. Electric space heaters are safe alternatives. If you do not have one, layer clothing, use sleeping bags, and relocate to a warm shelter before resorting to unsafe heat sources.

N/A

Pro tip: CO is odorless and colorless. If anyone in the household has headaches, dizziness, or nausea during a heating outage, open windows immediately and move everyone outside. These are carbon monoxide poisoning symptoms.

6. Open faucets to prevent pipe freezing during heating failures

When your furnace or heat pump stops working in freezing weather, your pipes are at risk. Water expands when it freezes, splitting copper and PVC pipes. Open all faucets (hot and cold) to a thin, steady stream — moving water freezes at a lower temperature than standing water. Start with faucets on exterior walls, which are most vulnerable. If you have a basement, keep the basement door open so heat from upper floors can reach the pipes below.

5 minutes

Pro tip: Open cabinet doors under sinks on exterior walls to let room heat reach the pipes. The air inside closed cabinets is several degrees colder than the room, and those pipes freeze first.

7. Call for professional service — here is how to get priority scheduling

During extreme weather, every HVAC company in your area is overwhelmed with calls. To get priority service: call early in the morning when dispatch schedules are fresh, describe the urgency clearly (elderly residents, infants, medical equipment that requires climate control), and ask about emergency or priority scheduling fees. Be honest about the severity — companies triage calls, and genuine safety risks get served first.

10 minutes

Pro tip: If you have a home warranty or HVAC maintenance contract, call that provider first — they are contractually obligated to respond within a specific timeframe, typically 24–48 hours, and the service is covered under your agreement.

8. Document the failure for warranty or insurance claims

If your HVAC system is under manufacturer warranty, the failure needs to be documented by a licensed technician to preserve your warranty claim. Photograph the unit, any error codes or blinking lights on the control board, and any visible damage (ice, water, scorch marks). Note when the failure started and what symptoms preceded it. Keep receipts for any emergency expenses (space heaters, hotel stays) — these may be reimbursable under your warranty or homeowner's insurance.

10 minutes

Pro tip: Many HVAC control boards display diagnostic codes via LED blink patterns. Count the blinks, note the color, and tell the technician — this speeds diagnosis by letting them bring the right parts on the first visit.

Bonus Tip

Know your insurance policy coverage before an emergency happens

Review your homeowner's insurance policy now — before a hvac emergency — to understand what types of failures are covered, what your deductible is, and what documentation the insurer requires. Most policies cover sudden failures but not maintenance neglect. Knowing your coverage in advance prevents costly mistakes during the stress of an actual emergency.

What to Avoid

  • Attempting DIY repairs on gas lines, electrical systems, or sewage — these involve genuine safety hazards that require professional training and equipment.
  • Running a failing system because 'it still kind of works' — partial operation often causes cascading damage that turns a repair into a replacement.
  • Ignoring the problem because the immediate crisis passed — the underlying cause does not resolve itself and will recur, usually at a worse time.
  • Hiring the first contractor who answers without verifying license, insurance, and asking for a written estimate — emergency pricing varies widely, and urgency is not an excuse for overpaying.