1. Panel upgrades or replacements
Replacing your electrical panel — whether upgrading from 100 to 200 amps or swapping a defective brand — always requires a permit. The permit triggers an inspection that verifies the new panel is properly grounded, bonded, and connected. It also creates a record with your utility, which needs to know the service capacity at your address. An unpermitted panel swap can result in your utility refusing to reconnect service if they discover it.
Pro tip: The permit for a panel upgrade typically costs $75-$200. The cost of removing and re-doing an unpermitted panel at resale: $3,000-$6,000.
2. Adding new circuits or branch wiring
Running a new circuit from the panel to any location in the house — a new outlet in the garage, a dedicated circuit for a window AC, a circuit for a kitchen remodel — requires a permit. The inspection ensures the wire gauge matches the breaker size, the circuit is properly protected, and the installation meets current NEC requirements. A single new circuit is a simple permit, usually processed same-day.
Pro tip: Some jurisdictions allow homeowners to pull their own permits for minor electrical work. Check with your building department — even if you hire an electrician, understanding the permit process gives you oversight.
3. Any work involving the service entrance or meter
The service entrance — the cable from the utility transformer to your meter and from the meter to your panel — is the highest-voltage, highest-amperage connection in your home. Any work on the weatherhead, service mast, meter base, or main disconnect requires a permit, a utility coordination, and an inspection. This is not DIY territory under any circumstances. Unpermitted service entrance work can result in utility disconnection.
Pro tip: Service entrance work often requires a utility shutoff before the electrician can work safely. The permit application triggers the utility coordination process automatically in many jurisdictions.
4. Installing or modifying a subpanel
A subpanel distributes circuits from the main panel to a specific area — a detached garage, a finished basement, or an addition. Installing a subpanel requires a permit because it involves a feeder circuit from the main panel, a separate grounding electrode in some cases, and proper neutral-ground bonding that differs from the main panel. Incorrectly bonded subpanels are one of the most common and most dangerous electrical deficiencies found in inspections.
Pro tip: The #1 subpanel mistake: bonding the neutral bus to the ground bus. In a subpanel, neutral and ground must be separated. The main panel is the only location where they bond together.
5. Installing hardwired appliances: EV chargers, generators, hot tubs
Any hardwired 240V appliance — Level 2 EV chargers, standby generators, hot tubs, electric vehicle supply equipment — requires a dedicated circuit and a permit. These appliances draw significant current, require specific wire gauges and breaker sizes, and often need GFCI or AFCI protection. The permit ensures the circuit can safely handle the continuous load and that the installation won't overload your panel.
Pro tip: Keep the permit and inspection records with your home's important documents. These records prove to future buyers, insurers, and appraisers that the work was done legally and safely.
Bonus Tip
Like-for-like replacements usually don't need a permit — but confirm with your jurisdiction
Replacing an existing outlet, switch, or light fixture with a similar one (same voltage, same amperage, same location) is generally exempt from permit requirements. But adding GFCI outlets where none existed, changing outlet locations, or upgrading from 15A to 20A outlets may cross the line into permitted work. When in doubt, a 5-minute call to your building department clarifies whether your specific project needs a permit.
What to Avoid
- Letting an electrician convince you that permits are 'optional' or 'just bureaucracy' — permits protect you, not them.
- Pulling a permit as the homeowner when a licensed electrician is doing the work — the permit should be in the contractor's name so they bear liability for code compliance.
- Assuming minor work like adding an outlet doesn't need a permit — in many jurisdictions, any new circuit requires one.
- Forgetting to close out the permit after the inspection passes — an open permit on your property title complicates future sales.