Masonry Cost (2026): Brick, Stone Veneer & Repointing Prices

Cost Breakdown

Item Low Average High
Mason labor, per hour Billed rate for a bricklayer or stonemason. Stone fitting, arches and historic mortar work sit near the top. $70 $95 $120
Helper labor, per hour Mixes mortar, moves material and sets scaffolding. A mason with a helper runs $840-$1,440 per 8-hour day. $35 $45 $60
Minimum charge, per visit Applies to small repairs such as a few loose or cracked bricks. $300 $400 $500
Repointing mortar joints, per sq ft Old mortar removed and joints refilled. Decorative two-color tuckpointing runs $15-$30 per sq ft. $8 $14 $20
Brick replacement, per brick Damaged brick cut out and a matching brick laid; the minimum charge applies to small counts. $15 $25 $35
Freestanding brick wall, per sq ft of face Two bricks thick with footing and cap. A 20 ft x 3 ft garden wall runs $2,400-$4,800. $40 $60 $80
Brick veneer on a house wall, per sq ft One layer of brick tied to an existing wall, with standard brick at $0.60-$1.50 each. $20 $28 $38
Manufactured stone veneer installed, per sq ft Material $6-$12 plus labor and setting materials $7-$13. $13 $19 $25
Natural thin stone veneer installed, per sq ft Material $10-$20 plus labor $10-$20. Full-thickness stone runs $35-$60. $20 $30 $40
Rebuilt brick steps, per step (4 ft wide) Brick over a block or poured core. Four steps with a small landing run $2,500-$5,000 with removal. $350 $525 $700
Brick entrance column, each About 2 ft square and 5 ft tall with footing, core and cap. Porch piers run $500-$1,100. $1,200 $1,700 $2,200
Brick chimney rebuild, per vertical ft Includes scaffolding and tear-down. Top 4 ft: $1,600-$4,000. A new crown alone: $800-$2,000. $400 $700 $1,000

Average Total Cost: $300-$800 for a small brick repair; $800-$2,000 to repoint 100 sq ft; $2,400-$4,800 for a 20 ft garden wall; $2,600-$5,000 for 200 sq ft of manufactured stone veneer

Factors That Impact Cost

Type of work

Repairs such as repointing run $8-$20 per sq ft, while new construction such as a freestanding brick wall runs $40-$80 per sq ft and a chimney rebuild $400-$1,000 per vertical foot.

Labor time

Labor is the larger share of most masonry bills. A mason and helper cost $105-$180 per hour, and corners, curves, arches and piers slow the pace well below the 300 to 500 bricks a day possible on straight wall.

Material choice

Standard brick costs $0.60-$1.50 each, while reclaimed or handmade brick runs $2-$4. Natural thin stone veneer costs $20-$40 per sq ft installed against $13-$25 for manufactured stone.

Height and access

Work above one story needs scaffolding or a lift, which often adds $300-$1,200 per job. Carrying material by hand through gates or up slopes also adds time.

Footings and structure

Walls, columns and steps need footings below frost depth. Deeper footings in cold-climate states and reinforced cores for gate columns raise the price.

Job size

Small repairs are billed at the $300-$500 minimum, so a handful of bricks costs more per brick than a larger repair priced at $15-$35 each.

Matching existing masonry

Matching older brick and mortar color may need special orders, reclaimed brick and test patches, which add modest cost and noticeably improve the result.

Money-Saving Tips

  1. Spot repoint only the failed joints at $8-$20 per sq ft instead of the whole wall when the rest of the mortar is firm.
  2. Combine small repairs in one visit so the $300-$500 minimum covers several items: loose bricks, a cracked cap and worn joints together.
  3. Repair early. Repointing a chimney for $780-$2,400 costs far less than rebuilding its top 4 ft for $1,600-$4,000.
  4. Choose manufactured stone veneer at $13-$25 per sq ft for large exterior areas and keep natural stone for small focal areas.
  5. Use standard brick at $0.60-$1.50 each where an exact match to the house is not needed.
  6. Get at least three written estimates that state the measured area, the brick or stone, and the mortar type.
  7. Schedule work for mild weather. Winter protection and heated enclosures in cold-climate states add cost.
  8. Keep gutters and downspouts working and de-icing salt off brick steps, since water and salt cause most masonry damage.

When to Splurge

  • Pay for lime-based mortar matched to the original on homes built before about 1930; hard modern mortar can damage soft old brick.
  • Build proper footings below frost depth under walls, columns and steps instead of setting them on a shallow base.
  • Have exterior stone veneer installed with full water management: barrier layers, lath, flashing and a weep screed.
  • Add a reinforced, grouted core and built-in hinge plates to any column that will carry a gate.
  • Replace a failed chimney crown ($800-$2,000) and add a cap when the stack is repointed or rebuilt.